Proposed rule: FAA proposes expanding screw-replacement requirements for certain Dassault aircraft
Federal · applicability depends on the document
The FAA has proposed a rule covering certain Dassault FALCON 7X, FALCON 900EX and FALCON 2000EX airplanes.
It would expand applicability and screw-replacement locations, revise replacement compliance times and limit installation of affected parts under certain conditions.
The FAA says the proposal addresses an unsafe condition after affected parts were found in other areas of certain FALCON 7X airplanes and in additional FALCON 7X airplanes.
Based on the linked record from Federal Register ↗. Our reporting and verification standards.
Source, dates and supporting record
- Source published
- Nov 19, 2026
- Last checked
- Nov 19, 2026, 2:45 PM EST
- Record status
- Proposed rule
- Comment deadline
- Jan 4, 2027
Supporting excerpts
The FAA proposes to supersede Airworthiness Directive (AD) 2024-14-09, which applies to certain Dassault Aviation Model FALCON 7X, FALCON 900EX, and FALCON 2000EX airplanes.
Proposed rule
This proposed AD would continue to require the actions in AD 2024-14-09 and would require expanding the applicability to additional airplanes, expanding the locations for screw replacement, and revising the compliance times for parts replacement.
This AD would also limit the installation of affected parts under certain conditions.
Since the FAA issued AD 2024-14-09, affected parts have been found in other areas of certain FALCON 7X airplanes as well as in additional FALCON 7X airplanes.
The FAA is proposing this AD to address the unsafe condition on these products.
Original source text
Source wording and its time zone may differ. Date-only dates are preserved. Timestamps here use Eastern Time. Evidence version: b74678f99c4be2b5d173970d76b6fca36840998c1a942bdd45eeed2b8f6ddcc2
Source guidance
Original guidance from the issuing source. For current warnings and instructions, consult that source directly. This site is not an emergency notification service.
